Reasons and solutions for common faults of packaging machines

A. The heat sealer body of the packaging machine fails to heat up

The reason for the failure of the heat sealer body:

1. The wires of the packaging machine is faulty;

2. The heating tube of the packaging machine is faulty;

3. The fuse of the packaging machine is damaged.

 

Troubleshooting of heat sealer body:

1. Check the wires of the packaging machine, find faults and carry out line maintenance.

2. If the heating tube of the packaging machine fails, the easiest way is to replace the heating tube directly.

3. When the insurance tube of the packaging machine is damaged, it is good to replace the insurance tube in time.

 

B. The temperature of the heat sealer body of the packaging machine cannot be controlled

Reasons for abnormal temperature of heat sealer body:

1. The temperature controller of the packaging machine fails;

2. The thermocouple circuit of the packaging machine is short-circuited.

 

Solution for abnormal temperature of heat sealer body:

1. When the temperature controller of the packaging machine fails, it is recommended to replace the temperature controller.

2. When the thermocouple circuit of the packaging machine is short-circuited, it is recommended to replace the thermocouple.

 

C. Reasons for not sealing tightly:

1. The sealing temperature of the packaging machine is lower than the normal temperature;

2. The material distribution of the packaging machine is uneven and the material is irregular;

3. The pressure at the sealing part of the packaging machine is uneven.

 

The solution for the seal is not tight:

1. When the sealing temperature of the packaging machine is lower than the normal temperature, it is necessary to increase the sealing temperature of the packaging machine.

2. When the material distribution of the packaging machine is uneven and the material is irregular, it is necessary to trim the irregular packaging material.

3. When the pressure at the sealing part of the packaging machine is uneven, it is necessary to adjust the sealing pressure value of the packaging machine.

 

D, the seal position of the packaging machine is not correct

Reasons for improper sealing:

The position of the heat sealer body of the packaging machine is set incorrectly.

Improper sealing solution:

When the position of the heat sealer body of the packaging machine is set incorrectly, it is necessary to adjust the position of the heat sealer body of the packaging machine.