In the process of our daily use of the packaging machine, various small problems often occur

in the packaging machine, which has a lot to do with our lack of timely maintenance and cleaning

in the daily process. Basic cleaning and basic maintenance of packaging machines.

1. This automatic packaging machine is an automatic control machine, so the packaging specifications are required to be unified.

2. Before starting operation, it is necessary to carefully check whether each part can operate normally, check whether there is abnormal noise or movement of each part, and make sure that each part is normal before it can be put into operation.

3. When adjusting the machine, the tools should be used properly. It is strictly forbidden to use excessive correction tools or use excessive force to remove parts to prevent damage to parts or damage to the machine.

4. After the machine is adjusted, be sure to tighten the loosened screws, and use a tool to turn the machine to check whether its posture meets the requirements before it can be put into use.

5. The machine should be kept as clean as possible. It is strictly forbidden to have oil stains, liquid medicine or slag of tempered glass on the machine to prevent damage to the machine.

6. During the production process of the machine, if other debris affects the operation of the machine, it needs to be removed immediately

7. It should be cleaned once a week, especially when cleaning the areas that are not easy to remove in normal use or blowing it with high-pressure air.

8. Maintenance parts, once a month, check the gear rack, worm, anchor screws on the lubricating block, roller bearings and other moving parts for flexible rotation and damage, if any defects are found, they should be repaired immediately, and can not be used immediately .

9. The machine should be used in a dry and clean room, and cannot be used in places where the air contains alkalis and other gas products that are corrosive to the machine.

10. If it is not used for a long time, try to wipe the whole body of the machine to remove it, apply anti-rust oil to the smooth surface of the parts, and cover it with a cloth.

11. After the machine is used or stopped, the rotating drum should be selected to clean and brush the remaining materials in the bucket, so as to make sufficient preparations for the next use.